Flexstar CMH Grow Light Fixture - 315W + Philips 930 Lamp

Ceramic Metal Halide (CMH) 315W Grow Light Fixture (Ballast Included)

Full Spectrum Light

• Plants evolved to use the entire range of sunlight - both short and long wavelengths.
• CMH grow lights provide full spectrum, one lamp can be used for both veg and bloom stages during a full grow cycle.

Energy Efficient & High Yield

• There is no doubt that the most important attribute of any bulb is yield per watt
• Compare with traditional MH or HPS bulbs, CMH grow lights produce an equivalent amount of light at about half the total watts consumption!

Low Heat

• It is important to keep the grow room at an ideal temperature. CMH grow lights run much cooler than the traditional lights. They are also the ideal light for small spaces like tents, closets or spare rooms.
• 1 Year Warranty

Protection

• Open circuit protection

Specifications

Philips Master GreenPower CDM-TP Lamp - 315W | 930 | Full Spectrum

These state-of-the-art lamps generate a greater level of useable plant light (photosynthetically active radiation) and run with a blinding intensity that's immediately apparent to the naked eye. The lamp is full-spectrum so it will produce the goods in both veg and flower – expect to see increased growth rates, tighter internodes, an improvement in overall vigour and an increase in final weight.

• Philips CDM-TP 315w/930 – full spectrum lamp
• A blinding intensity that's clearly visible with the naked eye
• Ideal as both supplementary and standalone lighting>
• Highly efficient - puts out 1.9 micromole (umol) per watt of electricity
• Extremely high PAR levels

Using the Philips Master GreenPower 315W CDM Lamp:

Hold with a clean cloth and screw the lamp into the bulb-holder fitting of your reflector until it will turn no further. It is important that the lamp is screwed very firmly into the holder. Failure to fit the lamp tightly will cause arcing inside the holder between the centre connector and the contact on the lamp. This will melt the solder contact on the lamp and irreparably damage it. Ensure the lamp is completely clean and free of dirt, grease and finger-prints etc. before switching it on.

Warning: When HID lamps are switched on they run extremely hot. As with all high-pressure sodium and metal halide bulbs it is necessary to avoid touching the lamp with anything such as fingers or plants as this may cause severe burns or fires. In particular avoid sprays or liquids coming into contact with the lamp as this may cause premature failure or even an explosion.

As with all lamps the light output they produce will decrease with use over time. One Stop Grow Shop recommends you replace your lamp regularly to maintain your garden efficiency.

Light Technical

Operating And Electrical

Controls & Dimming

Approval and Application